![]() |
#1
|
|||
|
|||
Built laser using buildlog.net
I am looking for the member that built a laser following the buildlog.net site.
Thanks Nils |
#2
|
|||
|
|||
was that Rad Racer?
|
#3
|
|||
|
|||
I think it was. Thanks
|
#4
|
|||
|
|||
Hey Nils, I just started buying parts for v2 of that laser. Are you considering building one yourself?
|
#5
|
|||
|
|||
Tom,
Thanks for responding. Are you using a website for your build? What power are you using for your laser? You want to cut aluminum? |
#6
|
|||
|
|||
I'm planning an 80w, 35-36" x 50ish. I'm not sure if it will cut aluminum, I just don't know enough about the power requirements for it.
|
#7
|
|||
|
|||
Oh, yes I will bE using the site as reference only.
|
#8
|
|||
|
|||
Hi Sailfl,
Sorry for the extremely late post/response.....I have not logged into this site for a long time. How can I help you out? Rad Racer |
#9
|
|||
|
|||
How thick of material can a laser cut through? Can it cut 1.25 composite material? Just wondering.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
And another MM will be built in Belgium | bramvh | Introduce yourself and start planning | 9 | Fri 15 April 2016 14:01 |
Introduction, Built, Cutting #90 - Ottawa Canada | Kevin Ford | MechMates already cutting | 15 | Sun 15 January 2012 02:12 |
Built a few more - Cape Town, South Africa | Gerald D | MechMates already cutting | 171 | Sun 07 August 2011 04:29 |
Home built power suply for MM | Carlos Mariche | 702. Power Supplies | 2 | Sun 12 September 2010 15:56 |
The MM is built. Now what ? - Building the business on 5 questions | gixi | Miscellaneous / General / Whatever / Catchall | 1 | Tue 13 October 2009 10:07 |