MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Computing, Software & Programming > 80. Computer Hardware & Software
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Sun 22 September 2019, 20:10
lonestaral
Just call me: Al #114
 
Isarn
Thailand
Send a message via Skype™ to lonestaral
Latte Panda driver

I was talking with my I.T. friend yesterday about Latte Panda.

https://www.lattepanda.com/

It should be possible to use one of these to run my MechMate.

http://www.lattepanda.com/products/3.html

Any comments or suggestions welcome.

It is about time to move away from old computers and parallel ports.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
110 volt stepper driver...no need for PS? IMMark 701. Motor Drives 4 Tue 19 February 2013 23:39
UIM 240xx step driver help. window_s CNC motion control software 13 Mon 01 August 2011 05:17
Planning for stepper driver same79 Archives 2 Wed 01 December 2010 15:40
digital stepping driver KenC 701. Motor Drives 7 Sun 20 June 2010 10:20


All times are GMT -6. The time now is 08:36.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.