#1
|
|||
|
|||
Coat Rack
Making a new coat rack for myself. It is 40" long about 10.50" wide, ran about 3 hours . Need to do a little sanding and staining add some hooks and she will be ready to hang on the wall.
|
#2
|
|||
|
|||
Nice Leo, hope you made little drilling marks with your MechMate where you will be putting in hooks for the coats. I do this then I know the things are spaced evenly.
Show us a picture when it is finished. |
#3
|
|||
|
|||
Done
Here you go Kobus, My camera does not work as well as yours. But here are a couple pics. The screws to mount this to the wall where to be under the hooks so they would not show. But when I started to hang it there where no studs in the wall ,that were spaced like I needed to let me center the thing where I wanted to put it. So I asked my wife if she would ever want to move it later on and she said no, so off I went to get the double sided tape I had left over from my build . I know I will regret this someday but not today HA HA !!
|
#4
|
|||
|
|||
Next time you run into the problem of studs not being in the correct place try one of these..... http://www.easyanchors.com/ They work really well!
|
#5
|
|||
|
|||
I like I like it very much. Hope the double sided tape will hold the load if all 8 hooks are full of coats. Otherwise you might have a new ventilation / inspection hole in that drywall someday
|
#6
|
|||
|
|||
Leonard,
Your coat rack looks great. Thanks for sharing the final piece. |
#7
|
|||
|
|||
Leonard, looks great also. What I would do if I were you is to buy some drywall anchors and screw them into the wall then use screws to attach the coat rack to the wall. If you have plaster they have anchors for that purpose.
Good job |
#8
|
|||
|
|||
Leo - what stepover do you use and what is the ball nose bit size
|
#9
|
|||
|
|||
Coat rack
Thanks to all . Irfan , I ran a .062" Dia 15 deg cutter at .012" step over. I ran it all in one pass with an edge prep on the boarders. Cut speed 200 IPM
|
#10
|
|||
|
|||
Leo,
Very Impressive. I love the stain colour. |
#11
|
|||
|
|||
Nice work Leo, love the design.
What did you use for design software.....ArtCam? |
#12
|
|||
|
|||
Hi Wayne , I bought the image of the goose. Just drew the outlines in 2D , the basket weave is just a texture and programed it in mastercam. Thanks , Leo
|
#13
|
|||
|
|||
Another Goose
Here is another one with some live action 12" x 36" .
http://www.youtube.com/watch?v=SthCAs1kOSM |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Carved coat rack #41 Soddy Daisy, Tn | Castone | MechMates already cutting | 43 | Sun 17 January 2010 03:21 |
Shelves, Coat Rack and 3D relief! | Alan_c | The Show Room | 11 | Tue 20 October 2009 06:35 |
Signs, Coat Racks, Shelves and 3D! | Alan_c | The Show Room | 6 | Fri 21 August 2009 06:39 |
3D carved Central ornament | javeria | The Show Room | 10 | Mon 03 August 2009 15:50 |