#1
|
|||
|
|||
motor problems vexta pk296a2a-sg7.2
I am currently running the VEXTA PK296A2A-SG7.2
I was having an issue with a small amount of chatter in my cuts so I switched from running the 20 tooth gears to a 30 tooth gear thinking the bigger dia. may smooth out the cut with more gear contacting the rack but what happened was I ended up with more backlash, I wasn't surprised I thought that this might happen, but I didn't think it would be this bad, and I was wondering if anyone else has had the same issue?? the backlash on the Y axis is about 13 thousands of an inch and on the X it is 7 thousands on one side and 20 thousands on the other is this a normal amount of backlash? I was wondering if I am expecting to much from the machine? thanks //chopper |
#2
|
|||
|
|||
See:
Backlash in the gearhead of the Oriental Motor PK296A2A-SG7.2 The first post has been moved to that thread for further discussion. This thread now closed |
|
|