![]() |
#1
|
|||
|
|||
Hello From North GA
Hi, My name is Dave. I just recently completed the frame of my MM. I am getting ready to start on the Z-Slide. I work on it when spare time allows.
It is designed to cut 4x4. I primarily cut 1 and 1.25 inch Extira. Thank you. |
#2
|
|||
|
|||
Hi Davey - I would say welcome but it looks like you've been hanging around here a while. Looking good! Send more build pics and welcome! There, I said it anyway.
|
#3
|
|||
|
|||
Thank you. I started this about 6 months ago.
|
#4
|
|||
|
|||
Welcome Davey.
Are you going to put some cross bracing on the frame. Perhaps it is there and I need new glasses. |
#5
|
|||
|
|||
I am. I have 3 pieces for the bottom. They were so rusty I had to sand them down good and prime them.
|
#6
|
|||
|
|||
Hi Dave. Nice pics. Post more when you get the chance. Would love to follow the progress.
|
#7
|
|||
|
|||
I will thanks.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hi From North Florida and NEED Help :) Will Pay :) | jburton | Troubleshooting | 1 | Thu 21 June 2012 13:19 |
Hello from North Dakota | ThorsFoundry | Introduce yourself and start planning | 2 | Sun 15 January 2012 17:58 |
New Build in planning Mid North NSW Australia | delco | Introduce yourself and start planning | 4 | Tue 12 April 2011 04:58 |
Newby from North Dakota | bwp | Introduce yourself and start planning | 3 | Sun 12 December 2010 18:50 |
Add one more CNC addict - North Carolina | rodom | Introduce yourself and start planning | 0 | Tue 01 December 2009 05:54 |