#61
|
|||
|
|||
Speaking of the devil, an hour ago, I just got sparks flying when a piece of loose wood got caught by the spindle & rub on the collet holder long enough to get ignited...
The spark went as far as my Thien separator... Consider myself lucky by not burning the shop down... |
#62
|
|||
|
|||
I looking for a Gecko G203V and Motor 34 HS 9801. New or second hand, Kobus has inspire me (again) to make a 4 axis. This is what I have on my MM and can used it for spare if needed
Can somebody give me good directions on a water cool spindle and drive Or is somebody planing to import stuff something to South Africa |
#63
|
|||
|
|||
Are somebody going to import things for there MM. I want to import the following:
Gecko G203V and Motor 34 HS 9801 Francois 082 431 0163 / 012 842 4066 |
#64
|
|||
|
|||
You can try Greg at CNC direct for the Gecko, he does stock them, and he has motors, not sure if they are Motion King units though. http://www.cncdirect.co.za/htm/stepper.html and http://www.cncdirect.co.za/htm/sensor.html
|
#65
|
|||
|
|||
Dovetails
Thanks to Alan Wagner for the Dovetail wizard ($29)
|
#66
|
|||
|
|||
Nice. Explain how you go about doing it.
|
#67
|
|||
|
|||
Wow ! this is the best side clamp I ever saw !
|
#68
|
|||
|
|||
#69
|
|||
|
|||
Thanks
Thanks for posting about my site! Was wondering where the hits were coming from
|
#70
|
|||
|
|||
3D Printing
Did anyone do research on 3D printing in the past year:
I know here is a post of a year back: http://www.mechmate.com/forums/showt...light=printing See also Mach 3D add-on - http://cnc2printer3d.wordpress.com/software/ |
#71
|
|||
|
|||
Missing "Configure initial state" in Mach 3
Do any body know where I can I find the "Configure Initial state" in Mach 3. I am looking for the button "Shortest rot".
|
#72
|
|||
|
|||
You are looking at an older config screenshot
present one looks like this on a new screen you can see a label ROTATIONAL under it are -Rot 360 rollover -Ang short rot on G0 -Rotational soft limits |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Welding up the Table - Pretoria S. Africa | CoRn3 | Construction started, but not cutting yet | 73 | Sun 13 March 2016 04:39 |
New Things - Pretoria, South Africa | Marinus | Introduce yourself and start planning | 11 | Tue 22 December 2009 00:50 |
New MM in Cape Town, South Africa | anton | Construction started, but not cutting yet | 24 | Thu 03 December 2009 09:13 |
Hi there Dave from South Africa | kooskoek | Introduce yourself and start planning | 14 | Mon 17 August 2009 09:09 |