#1
|
|||
|
|||
Mechmate parts for sale in Norway
Many years ago I started collecting parts for building a Mechmate and started building the control box. After a while I ended up buying a CNC machine from AUS instead, and the parts have been sitting around gathering dust. Parts:
4x Motionking Motors 34HS9801 4x Geckodrive G203V drives DeskCNC serial breakout board Power supply Cabinet Rollers CNC cut parts from Kim Mortensen in Denmark (Still in the shipping box) Other stuff like some cables, emergency switch, cable chain, etc. The controlbox is in 'kitchenready' state, it works, spins the motors, and toggles a lightbulb, but could use some cleaning up, some wires could be shorter and could use a bunch of strips. It's setup with the DeskCNC serial breakout board, but could easily be changed to parallel port or USB breakout board. Most parts that I don't have should be available locally at 'reasonable' prices with the possible exception of rack and pinion which I've only found some very expensive sources for in Norway. I'd prefer to sell this in Norway since everything is already shipped to and taxed into Norway which is kind of expensive. I'm located in Sola, outside of Stavanger. If you have shopped around a little bit, you have an idea how much this would cost with shipping and taxes. Make me a reasonable offer. Will post pictures. Last edited by soulvoid; Wed 14 August 2013 at 03:33.. |
#2
|
|||
|
|||
I'm interested, contact me on PM
|
#3
|
|||
|
|||
Oh my god Sulvoid
That's a lot of years ago that I sent you those parts... I would have thought you already had built 10 machines since then... |
#4
|
|||
|
|||
Quote:
I had planned to retrofit the machine I bought with the mechmate motors and control box as the machine had a proprietary controller with no g-code, running ms-dos and using floppy disks... In the end I sourced the connectors used on the original controller, figured out the wiring and built a plug and play control box. Couldn't use the geckos as the voltage used on the motors with the original controller was 120v for two of the motors, third runs 60v just to make things interesting. So I still have the parts.. |
#5
|
|||
|
|||
Kitchen ready state. Long wires... Motor Motor Rollers I have a couple of these, dunno if I even planned to use them on the Mechmate. I also have three industrial strength limit switches and linear rails with bearing blocks, 20mm x 600mm or there about for an alternative z axis if interested. Last edited by soulvoid; Fri 13 September 2013 at 09:09.. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mechmate Parts for sale w/photos. Finally | stphnd22 | The Market Place | 14 | Wed 07 September 2011 20:25 |
Laser cut parts for sale | hack | Archives | 3 | Fri 15 July 2011 07:29 |
For Sale - selling all my Mechmate parts I have | David S | The Market Place | 25 | Mon 04 April 2011 21:47 |
The long road is getting shorter! - Tønsberg, Norway | edvard | Construction started, but not cutting yet | 14 | Sun 10 May 2009 22:59 |
Cutting tool from Norway | mrloeng | The Market Place | 0 | Fri 20 February 2009 08:57 |