MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Personal Build Histories > Introduce yourself and start planning
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #61  
Old Thu 01 May 2014, 18:33
danilom
Just call me: Danilo #64
 
Novi Sad
Serbia
The glue will fail for sure at some point

design an enclosure around the whole motor with some went holes at angle that water won't penetrate, in this scenario motor will rust for sure if sprayed with water (paint will hold it off but all of them have some scratch and they will rust eventually on that point), screws that hold the parts of motor will too, and the sticker protecting the back hole could peel off.
I can't say for the gearbox but I think that its not watertight, some who have opened them can say for sure if its or not.
Reply With Quote
  #62  
Old Fri 02 May 2014, 18:54
Guillermo
Just call me: Guillermo
 
Puerto Ordaz
Venezuela
Danilo.

Good point. Rust is a factor that I had not considered.

A motor inside a enclosure will be fine whenever we ensure it does not overheat.

That's something for what I will have enough time to review. For now I need to focus

on the kitchen table project.

Regarding to the PS wiring. 25V+25V parallel = 25 VAC x 1.4 = 35 VDC that is the

power needed. Could you or anyone else confirm if the diagram with red indications

is the one corresponding to this configuration.

Thanks.

Guillermo
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
The baby beast is cutting away - Peurto Ordaz, Venezuela Hugo Carradini MechMates already cutting 176 Sun 15 April 2012 07:47
MM Amazonas/Venezuela alexguan Introduce yourself and start planning 0 Wed 19 May 2010 07:50
CNC para Venezuela suzuki039 Introduce yourself and start planning 4 Thu 04 February 2010 20:26
Project? n-ghadimi Introduce yourself and start planning 1 Tue 03 November 2009 06:03
Alternatives to Laser Cutting - Waterjet, Plasma, Oxy-fuel? Rob Smith Profiled (laser cut) & bent steel plate 26 Sun 25 January 2009 11:30


All times are GMT -6. The time now is 00:32.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.