|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Gcode for surfacing table
Gerald I do not know if this is right thread for this? As far as I remember JR also had similar question.
Is there any particular sequence in gcode while surfacing table or should I put simple gcode for doing so? |
#2
|
|||
|
|||
DMS,
If you're using Mach, there is a surfacing wizard. Find it on the top toolbar. Chuck |
#3
|
|||
|
|||
Thanks Chuck, I was not aware of that. I used JR's file for my setup.
|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|