![]() |
#1
|
|||
|
|||
Latte Panda driver
I was talking with my I.T. friend yesterday about Latte Panda.
https://www.lattepanda.com/ It should be possible to use one of these to run my MechMate. http://www.lattepanda.com/products/3.html Any comments or suggestions welcome. It is about time to move away from old computers and parallel ports. |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
110 volt stepper driver...no need for PS? | IMMark | 701. Motor Drives | 4 | Tue 19 February 2013 23:39 |
UIM 240xx step driver help. | window_s | CNC motion control software | 13 | Mon 01 August 2011 05:17 |
Planning for stepper driver | same79 | Archives | 2 | Wed 01 December 2010 15:40 |
digital stepping driver | KenC | 701. Motor Drives | 7 | Sun 20 June 2010 10:20 |