MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Computing, Software & Programming > CNC motion control software
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Reply
 
Thread Tools
  #1  
Old Fri 19 September 2008, 12:48
DMS
Just call me: Sharma #9 India
 
Rajasthan
India
Gcode for surfacing table

Gerald I do not know if this is right thread for this? As far as I remember JR also had similar question.

Is there any particular sequence in gcode while surfacing table or should I put simple gcode for doing so?
Reply With Quote
  #2  
Old Tue 07 October 2008, 18:35
skypoke
Just call me: Chuck
 
Port Aransas
United States of America
DMS,

If you're using Mach, there is a surfacing wizard. Find it on the top toolbar.

Chuck
Reply With Quote
  #3  
Old Sun 12 October 2008, 09:09
DMS
Just call me: Sharma #9 India
 
Rajasthan
India
Thanks Chuck, I was not aware of that. I used JR's file for my setup.
Reply With Quote
Reply

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 10:26.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.