#1
|
|||
|
|||
Anybody from Canada selling pre made parts, and what should I expect to spend?
Hey Everybody
I want to build one of these machines, but don't have access to laser cutting, is anyone in Canada selling pre-made parts? Also I am wondering what sort of budget I should be looking at for getting the structure of the machine built I know steel is probably cheaper in some areas than others but just looking for a number. Thanks Guys |
#2
|
|||
|
|||
Hi Mitch,
Welcome aboard Is this Sussex, NB, Sussex county near Ottawa or another one I’m forgetting ?! There or else, surely there is Laser cutting place nearby worth you to find out about. Otherwise, Heath ( domino 11) will chime in and be glad to assist you with his contacts as this Canadian group buy may need to be awaken As for my parts, I got them locally through two laser place to keep price as low as I could. Fortunate for me, there is +/- 6-8 of those places with in 100km around ! So, In my opinion, it would be worth to search in your local area or even in your province as It could be beneficial ! Good luck, Amicalement, Robert |
#3
|
|||
|
|||
Mitch,
I sent you a pm with the details. |
#4
|
|||
|
|||
Hey Robert and Heath
Thanks for the info, yes Robert I am from Sussex, NB, I have been looking around but haven't turned up much, I believe there is a water jet cutting shop in Moncton but will that suffice for quality, it should?, shouldn't it? Heath got your PM will reply. Also I am going hunting for some steel channel and tubing this weekend, there are some junk yards around that I plan on visiting, any thoughts on getting scrap. |
#5
|
|||
|
|||
Good hunting Mitch
Hi Mitch
Good luck with the build. I'm still at the "research stage" but hope to get moving once i finish my roofless barn in order to house the beast. I'm from Ireland, but my brother Seamus lives near St Davids with his Canadian wife. I think this is near you. All the best Tony |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Laser Cut Parts from Ontario, Canada | domino11 | Profiled (laser cut) & bent steel plate | 90 | Sat 28 April 2012 21:26 |
Mcmaster not selling outside US | kanankeban | The Market Place | 35 | Wed 25 February 2009 16:04 |
Spindle pre-planning questions | rdfl | 50. Toolheads | 3 | Thu 05 February 2009 12:09 |
Best Pre-Made Z Slide for a ShopBot retro-fit? | Cutter99 | 40. Z-Slide | 2 | Wed 17 December 2008 15:22 |
laser burnt pre-bent parts | ghostlx | Archives | 4 | Mon 22 September 2008 05:18 |