![]() |
#1
|
|||
|
|||
Best price 4 /1 timing pulleys
Looking best price to make a 4 to 1 ratio timing pulley reduction
could really use exact part numbers and matching seller sites really need to get my cost down going broke no overtime in this bad economic situation and i am now at the point of just buying parts i am not making |
#2
|
|||
|
|||
I have complete sets of 4:1 that I can ship. Also if you need them I have axles and bearings that will work in my motorplates or in other plates.
|
#3
|
|||
|
|||
A complete set being 3 sets two sets for my x axis and one set of my y axis?
Also belts to match my machine design is a variation of mechmate so motor plates are different still a gear rack design |
#4
|
|||
|
|||
What about your z axis? You need 4 really.
x1 x2 y z are the required axis motors |
#5
|
|||
|
|||
Smrish i have totally built screw drive for the z axis sorry i didn't explain this i have thirty yrs of machining exp. And i have really design my machine as a cross between a mechmate and another machine my next machine will be completly different given and easier way to make parts not on a manual mill
|
#6
|
|||
|
|||
I didn't use a mill to build my MM; I don't have to
![]() |
#7
|
|||
|
|||
Mike, I need a set of timing pulleys, just 1 pair. need 1/4" bore for motor and 3/4" bore for driven. do you have and do you take paypal? thanx....pete
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
shaft coupling or timing pulleys? | coinhunter | Construction started, but not cutting yet | 4 | Sat 16 July 2011 00:57 |
Source for timing pulleys | DTGuitars | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 4 | Tue 05 October 2010 07:39 |
Toothed, Timing Belt Suppliers | Victorian Signs | Driving Mechanisms: Rack/pinion, gears, screws, belts & chains | 5 | Sun 16 August 2009 00:03 |
Timing pulleys made easy | stcnc | The Market Place | 0 | Mon 08 September 2008 15:02 |
Steel price increasing | ekdenton | Archives | 8 | Mon 14 April 2008 06:43 |