|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Rack is bowed - is it a problem?
Hi,
I don't remember reading the required quality of the rack. Please do remove if this has been discussed elsewhere. My racks have some bow in/out/side a little, about +/- 1mm over 60cm (I place a frame square over it & measure the gaps.) Will this be a problem? |
#2
|
|||
|
|||
1mm in 600mm sounds straight enough. I am sure that you can close that with one finger's pressure and the tape should hold that with no problem.
|
#3
|
|||
|
|||
Gerald,
Thanks again for a fast reply, one question leads to another. I also observe that I can't mash 2 racks teeth to teeth perfectly, is this a problem? This is on the right end one end of rack.jpg this is on the left end left end of rack.jpg |
#4
|
|||
|
|||
Mach allows you to compensate for these differences (see "screw mapping") but I havn't heard that this is used for racks. What does your supplier say about his quality? It may be his normal standard . . . .
|
#5
|
|||
|
|||
I have not ask them yet. My pass experience with racks are module 10 and larger, they normally mesh up nicely with acceptable tiny gaps but Module 1 is so small & I'm puzzled.
This one looks like there is a cumulated error along the whole length... |
#6
|
|||
|
|||
Sorry to see this.
Have you tried brushing along the teeth with a wire brush to be shure no leftover steelparts are inbetween teeth? I had the same leftovers and wondered why they don`t fit 100%. Yes, I`m a dentist and I`m obsessed with leftovers between teeth. |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with Main Longitudinal Beam | gixi | 10. Base Table | 32 | Thu 19 November 2009 14:23 |
Would you mind to help me to solve the problem for Keling stepper Motor Driver? | qangel1000 | Motors & their mountings | 6 | Fri 07 August 2009 23:42 |
Cutting in the UK! Electrical noise problem solved! - Darwen, UK | Barrie | MechMates already cutting | 5 | Fri 01 May 2009 09:25 |
Rack alternate | Art | Archives | 5 | Fri 12 September 2008 12:04 |
Kitchen table project started - Antek Power Supply problem | KevinL | Construction started, but not cutting yet | 6 | Fri 22 February 2008 21:10 |