|
|
#31
Tue 05 April 2011, 17:29
|
|||
|
|||
|
Thanks, Toad.
The Builder's Log entry uses the "cutting" dimensions of the table. What are the cutting dimensions of your MechMate? It looks to be about the size of a sheet of MDF, 97" X 49", but I'm guessing. The Updated Builder's Log is here. 
|
|
#32
Tue 05 April 2011, 19:08
|
|||
|
|||
|
Good day, Yes, you are correct.
Toad
|
|
#34
Tue 05 April 2011, 23:41
|
|||
|
|||
|
wow, great carvings
|
|
#35
Wed 12 October 2011, 11:35
|
|||
|
|||
|
Dust foot added.
Good day all,
Been quiet for a while, I have addes a dust collection system since last here, and cut a few things, don'r take pictures of most, but here is a couple. You all have a good day.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Upgrading the spindle already! - Myerstown PA USA | SumBum | Introduce yourself and start planning | 67 | Fri 26 March 2010 06:31 |
| Upgrading the vBulletin software that runs this forum | Gerald D | Archives | 54 | Mon 20 July 2009 03:26 |
| The control box is completed and the painted table moves! - Ft. Worth, Texas | kn6398 | Construction started, but not cutting yet | 52 | Wed 04 March 2009 22:22 |
| Completed Mechmates Album With Serial Nos. | vishnu | Archives | 3 | Sat 25 October 2008 11:53 |
| Upgrading a ShopBot PRT - Newman Lake, WA | mtgstuber | Construction started, but not cutting yet | 13 | Sun 11 November 2007 11:21 |
