![]() |
#2
|
|||
|
|||
I have tried to send you a pm but being such a low poster I'm not sure if you'll receive it ?
|
#3
|
|||
|
|||
Mark's machine was more fully described here: http://www.mechmate.com/forums/showthread.php?t=2537
Luke, the PM system here does not discriminate for low post counts, but the recipient may have selected to opt out of the PM system. |
#4
|
|||
|
|||
Hi Gerald thank you for the heads up on the Pm's previous forums that I have been part of would not allow Pm's unless you had over a specific amount of post's whithout the message turning up in the sent box I was usure it had sent. Many thanks for the link its informed me further about marks machine. I need to count the pennies and hopefully join the club! Again forgive me for not posting more I need to start an mm build ! Many thanks again for creating such a brilliant forum !
Last edited by lukelucas93; Fri 21 August 2015 at 14:15.. |
#5
|
|||
|
|||
Mark,
Is the offer is still on? I just need a few parts, ie. the Z-Slide. |
#6
|
|||
|
|||
Nikonauts, no sorry, all gone.
|
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parts no longer for sale. | jd.roberts | Archives | 9 | Tue 15 July 2014 13:16 |
Mechmate parts for sale in Norway | soulvoid | The Market Place | 4 | Fri 13 September 2013 08:42 |
Mechmate Parts for sale w/photos. Finally | stphnd22 | The Market Place | 14 | Wed 07 September 2011 20:25 |
Laser cut parts for sale | hack | Archives | 3 | Fri 15 July 2011 07:29 |
For Sale - selling all my Mechmate parts I have | David S | The Market Place | 25 | Mon 04 April 2011 21:47 |