#1
|
|||
|
|||
countersunk bit selection
Im searching the countersunk bits for countersink the holes, but need recomendation for this tool.
Im searching a good set for my workshop. And the best drill material recomendation. |
#2
|
|||
|
|||
Ros, can you give me some web pages where you normally select your tools? Then I can make suggestions from those pages. (otherwise we will have a lot of difficulty with the names in different languages)
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transformer Selection | KenC | 702. Power Supplies | 2 | Tue 21 July 2009 06:14 |
servo selection | ashish_hal | Archives | 3 | Wed 24 September 2008 07:13 |
Proper bit, speed an IPM for fir,pine and western red cedar | Art | Cutting various materials - bit selection, feeds, speeds | 6 | Mon 22 September 2008 15:25 |
Spindle selection | skypoke | 50. Toolheads | 11 | Fri 23 May 2008 04:20 |
1010123 Support Board - material selection (MDF, plywood, other . .) | IN-WondeR | 10. Base Table | 2 | Sun 27 May 2007 12:53 |