|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
melamine particle board. 6mm 2 flute
hi people
iam doing some cuts on melamine 18mm made of particles cant find the right feed and/or speed. i use SGS brand 6mm 90113 bits, its a two flute upcut and the downcut match. iam getting a little of burn on the bit. its getting black on the time. whats the optimal and fastest way to cut? i have a 3hp 18000rpm spindle and set the machine to move at 4600cm/min has normal operation. i found this calculator now http://zero-divide.net/index.php?page=fswizard will update on the test. |
#2
|
|||
|
|||
have made this calculation
http://zero-divide.net/index.php?pag..._tool_id=98309 will update how its going |
#3
|
|||
|
|||
Do you mean 4600mm/min? If so, that's much too slow. Try 8000-12000mm/min at 18,000 rpm.
|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
raw Particle board cutting | danilom | Cutting various materials - bit selection, feeds, speeds | 3 | Tue 19 June 2012 02:23 |
What to use to cut Melamine Board? | Daya | Cutting various materials - bit selection, feeds, speeds | 17 | Tue 13 March 2012 22:08 |
Straight-flute bits and safety | lumberjack_jeff | Cutting various materials - bit selection, feeds, speeds | 8 | Sat 27 March 2010 13:20 |
What is the purpose of a spoil board or bleeder board? | j_wizard | 10. Base Table | 1 | Sun 09 August 2009 17:00 |
Sizing Melamine Panels | hflwaterski | Archives | 8 | Sat 21 June 2008 06:11 |