#1
|
|||
|
|||
Noob here looking at first build
Hi Guys,
Just found this forum so I decided to join. I would like to build a router or a router/plasma set-up on the cheap, but I will not compromise quality. I am a good welder and have access to machine tools, through friends and school. My desire is to build a 4'x4' rig then see what kind of profit I can generate before going bigger. I have a lot of questions so bear with me. Cheers, RJ |
#2
|
|||
|
|||
Welcome to the group.
Keep reading - ask questions, it's okay - we don't bite! |
#3
|
|||
|
|||
If you can weld and have some machine access, you are all set.
Brush up on the software side. Also note that the difference in cost between a 4x4 and a 4x8' machine is maybe $400. |
#4
|
|||
|
|||
Welcome to the forum !!!
|
#5
|
|||
|
|||
Welcome aboard!
Best reading in the beginning is reading a bunch of the larger build threads. You can get a good sense of the work involved from them. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Noob build: 5 x 10 with roller bearing R&P | toolfool | Introduce yourself and start planning | 1 | Sat 25 September 2010 06:10 |