MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Electrical & Electronic > 70. Control Systems
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools
Old Wed 31 March 2010, 03:09
Just call me: Danilo #64
Novi Sad
Need opinion on breakout board

As I was looking for an cheaper and available in Europe Breakout Board (BOB), I found this one

It really looks ok, but can someone review the manual and see are there some problems and major differences from generally accepted pmdx?
it even has the option for din rail mount.

here is their manual:
Reply With Quote
Old Wed 31 March 2010, 06:47
Gerald D
Just call me: Gerald (retired)
Cape Town
South Africa
It looks okay, but the "manual" is a bit hard to understand. If mechapro has good support, then buy it.
Reply With Quote

Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Motors loosing steps - Breakout board not suitable mgandy02 Troubleshooting 17 Mon 02 November 2009 10:01
What is the purpose of a spoil board or bleeder board? j_wizard 10. Base Table 1 Sun 09 August 2009 17:00
Need opinion on round bar rails with roller Claudiu Rails & Rollers 3 Fri 03 July 2009 12:05
Power supply for the PMDX-122 Parallel breakout board - 9V AC from main transformer bradyaero 702. Power Supplies 14 Mon 01 December 2008 15:00
Alternative to Mach3 and Breakout Board using USB dmoore Miscellaneous / General / Whatever / Catchall 0 Thu 22 May 2008 12:59

All times are GMT -6. The time now is 12:32.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.