|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Before I buy could you guys please check my purchase
Hey guys I just want someone to please check out my math/thinking before I hit the buy button.
I want to purchase Kelings 640oz Steppers http://kelinginc.net/KL34H280-45-8A.pdf I would like to wire them Bipolar (Parallel) This would mean 6.3 amps and 2.2Mh Plucking away at the calculator produced a 47.46 Volts 16 amp (67%) 801 VA I was wondering if I can get away with a 50 volt 20 amp 1,000va power supply? More specifically this one http://kelinginc.net/KL-5020.pdf I have been punching away at the calculator for more than a week and feel like I am chasing my own tail. Thanks for the help guys. Russell |
#2
|
|||
|
|||
That is what I have on mine and I have not had any problems so far using the 5020 and have ran lots of long programs no problems with over heating so far.
|
#3
|
|||
|
|||
Are you using the 12v tap to power the BOB ?
|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3.5 guys built 3 MMs, 3 serial no.'s #49, #50, #51 ! - Knappa OR USA | DeadGuy | MechMates already cutting | 152 | Fri 12 March 2010 00:27 |
need someone to check my list | thereclinerman | 702. Power Supplies | 8 | Tue 17 November 2009 18:49 |
heres some guys could use some help from Art | revved_up | Miscellaneous / General / Whatever / Catchall | 0 | Tue 24 March 2009 09:52 |
Do not purchase Vacuum application drives from Geckodrive | kn6398 | 701. Motor Drives | 2 | Fri 14 November 2008 20:57 |
to build or to buy? | greginwa | Archives | 11 | Wed 23 January 2008 08:22 |