|
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
|
Thread Tools |
#1
|
|||
|
|||
Bit Supplier
Hi Everyone
Doe's anybody have a good supplier that is current for Compression bits also specialty bits preferably on the cheaper side. anywhere in the world but doesn't charge the earth for postage. I am using carbidechui for end and ball nose mills. Pete |
#2
|
|||
|
|||
I just found this place. The prices seem pretty fair all around. I've heard good things about southeast tool bits. I just placed my first order with them, set to arrive today.
http://www.carbideprocessors.com/ |
#3
|
|||
|
|||
Pete,
I'm also looking for some compession bits, I was after 1/4" or 6mm. Have you had any luck? Anthony |
#4
|
|||
|
|||
I have been using bits from Centurion Tools
http://centuriontools.com 1/4" Mortise Compression 1" Cut Length SKU: 14CR21.02.5FEM200 $27.80 I cut a lot of cheap China 3/4" ply and even after lots of sheet, they still give a good edge. If they do not ship out of the country, I would consider an order to one location if you are interested. |
#5
|
|||
|
|||
Multi cam
Hi
Sorry for the delay I found Multi Cam here in Brisbane thier prices are reasonable, postage is overnight freight. I found on another site that due to the fact that I was after 1.5mmCED you could not get them so the suggestion was run a 1.5 down cut spiral then an upcut through over two passes this has given great results. Cheers Pete |
Register | Options | Profile | Last 1 | 3 | 7 Days | Search | Today's Posts | Mark Forums Read |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moore Gear - Rack and Pinion Supplier USA | Diane-mooregear | The Market Place | 0 | Wed 13 July 2011 09:31 |
www.akcesoria.cnc.info.pl - Ogólne dostawca w Polsce (Supplier in Poland) | martin77pl | The Market Place | 4 | Sun 22 February 2009 13:15 |
Aussie Dual Vee & Rack Supplier | WillyInAus | Rails & Rollers | 2 | Wed 09 April 2008 01:42 |