#1
|
|||
|
|||
surfacing a table in EMC
For those of you who have surfaced your table using EMC, do you have any g code you could share?
I tried using the following which was generated by a script made by Switcher on CNCzone. Code:
G90 Z0.25 F100.0 X0.0 Y0.0 F100.0 Z-0.12 F25.0 G91 F50.0 X99 Y0.625 X-99 Y0.625 X99 Y0.625 EMC didn't like it. |
#2
|
|||
|
|||
Hi Jeff,
when I faced my table I used the generator located at the following link http://wiki.linuxcnc.org/cgi-bin/emc...ode_Generators Scroll down until you find "facing Software" Worked a treat for me. Jayson. |
#3
|
|||
|
|||
Thank you so much for this Jayson! What a cool link!
|
#4
|
|||
|
|||
FWIW, a variant of this code
Code:
% G17 #1=0 (X1) #2=0.375 (Y1) #3=98 (X2) #4=49.125 (finished Y area minus cutter radius) #5=0 G0 Z [0.5] G0 X #1 Y [#2 + #5] G1 X #1 Y [#2 + #5] Z0 F150 (set up feed) O101 WHILE [#5 LT [#4-#2]] G1 X #1 Y [#2 + #5] Z0 G1 X #3 Y [#2 + #5] Z0 G0 Z [0.5] #5 = [#5 + .65] (increments for the next reverse cut) G0 Y [#2 + #5] G1 Z0 G1 X #1 G0 z [0.5] #5 = [#5+.65] ( increments for the next cut) O101 ENDWHILE G1 X #1 Y [#4 ] Z0 G1 X #3 Y [#4 ] Z0 G0 Z [0.5] G0 X #1 % |
#5
|
|||
|
|||
Jeff,
An Onsrud 91-000 1.25" Spoilboard surfacing cutter makes quick work of resurfacing the top. The price is reasonable. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Surfacing the table | gixi | 10. Base Table | 1 | Mon 10 August 2009 05:17 |
Gcode for surfacing table | DMS | CNC motion control software | 2 | Sun 12 October 2008 09:09 |