MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: lunaj76
Forum: The Show Room Wed 20 July 2011, 21:46
Replies: 15
Views: 25,441
Posted By lunaj76
Hi David, Are you talking about top and...

Hi David,

Are you talking about top and bottom curve? These boards are just flat. I will be doing some boards that will be laminated into a curve. That will be down the road.

Justin
Forum: The Show Room Fri 15 July 2011, 21:32
Replies: 15
Views: 25,441
Posted By lunaj76
It is particle board with Laminate 2 sides. I...

It is particle board with Laminate 2 sides. I had the laminate laid up by a local company here.
Forum: The Show Room Fri 08 July 2011, 06:30
Replies: 15
Views: 25,441
Posted By lunaj76
HPL desk for a vets office

I could not have done this job without my Mechmate.
Forum: The Show Room Mon 13 June 2011, 22:43
Replies: 15
Views: 25,441
Posted By lunaj76
Long Boards

Cut some prototype skateboards of a local company here.
Forum: The Show Room Fri 17 July 2009, 21:06
Replies: 15
Views: 25,441
Posted By lunaj76
4 min rough pass w 1/4" ball nose, 26 min...

4 min rough pass w 1/4" ball nose, 26 min finishing pass w 1/8" ball nose. I was not contracted to do the finishing so I did not sand them. I only have these back because they want more and I need...
Forum: The Show Room Fri 17 July 2009, 10:36
Replies: 15
Views: 25,441
Posted By lunaj76
Flower Carvings and Skateboards! - Littleton, CO

I did these with a free cam software from here.

http://www.vectorart3d.com/machinist_free/
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -6. The time now is 03:13.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.