MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 4 of 4
Search took 0.00 seconds.
Search: Posts Made By: ger21
Forum: Troubleshooting Sun 24 May 2015, 07:34
Replies: 49
Views: 76,727
Posted By ger21
Cut your x axis acceleration in half, and see if...

Cut your x axis acceleration in half, and see if it helps.
Forum: Troubleshooting Sun 17 May 2015, 17:01
Replies: 49
Views: 76,727
Posted By ger21
At 100ipm, you want to be between 10,000-12,000...

At 100ipm, you want to be between 10,000-12,000 rpm. At 21,000, you're drastically reducing the life of the tool.
Forum: Troubleshooting Sat 16 May 2015, 20:35
Replies: 49
Views: 76,727
Posted By ger21
OK, then CV mode is causing the rounded corners....

OK, then CV mode is causing the rounded corners. Your accel is much too slow, and should be at least 10-15, if not higher. Also, in General Config, set "Stop CV on ANgles" to 89 and enable it.

The...
Forum: Troubleshooting Sat 16 May 2015, 18:51
Replies: 49
Views: 76,727
Posted By ger21
Are you sure? Is there a G61 or G64 in the status...

Are you sure? Is there a G61 or G64 in the status line in Mach3?

The rounded corner certainly looks like it's from CV mode.
What are your accelerations set to?


Do you have backlash...
Showing results 1 to 4 of 4

 
Forum Jump

All times are GMT -6. The time now is 00:32.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.