Forum: The Market Place
Sat 06 October 2018, 17:40
|
Replies: 1
Views: 8,685
Angle Grinder / Skate for Sale
Hello,
I made up an angle grinder / skate and used it to make my V-groove rails. It was a neat project and the rails came out great.
Now that my table is done, the tool is now just hanging...
|
Forum: CNC motion control software
Sun 13 October 2013, 21:02
|
Replies: 4
Views: 13,267
If anyone would like a deal on a Kmotion card,...
If anyone would like a deal on a Kmotion card, New in box, never installed along with a Kanalog card... let me know. We have had one sitting on the shelf for about a year.
We thought we were going...
|
Forum: General - MM Build
Wed 16 January 2013, 22:17
|
Replies: 1
Views: 5,512
Skate
The Skate is the orange metal jig attached to my grinder. The skate holds the grinder at a 45 degree angle. Then you attach sanding disks to the grinder and get busy for a few hours...
Total cost...
|
Forum: Rails & Rollers
Thu 12 April 2012, 05:43
|
Replies: 198
Views: 251,993
|
Forum: Rails & Rollers
Wed 11 April 2012, 16:29
|
Replies: 198
Views: 251,993
|
Forum: Rails & Rollers
Wed 11 April 2012, 14:20
|
Replies: 198
Views: 251,993
Hello Mike,
I just recieved my skate kit...
Hello Mike,
I just recieved my skate kit (THANK YOU!
Can you tell me which grinder the holes are setup for? Is it the Bosch 1375A?
I have to buy a grinder for this anyway... so I figure I...
|
Forum: The Market Place
Thu 05 April 2012, 05:47
|
Replies: 31
Views: 29,794
|
Forum: The Market Place
Wed 04 April 2012, 13:14
|
Replies: 31
Views: 29,794
Gerald you are reading my mind. My concern was...
Gerald you are reading my mind. My concern was that if we had a variation in height between 2 rails (wear, bad load into the machine, really anything that throws it off a few thousands) then we would...
|
Forum: The Market Place
Wed 04 April 2012, 12:25
|
Replies: 31
Views: 29,794
Thanks Craig!
I was wondering about that. ...
Thanks Craig!
I was wondering about that.
Going from an 8 to a 12 foot rail seemed to add a lot of shipping cost and hassle that didn't seem to justify itself (if you can do a touch of welding...
|
Forum: The Market Place
Wed 04 April 2012, 11:46
|
Replies: 31
Views: 29,794
12 foot rails V-rails or 6 6 ok?
Hi everyone!
My name is Charles and I just caught this thread about rail grinding.
We could probably make these rails in my shop on a regular basis... but the way I am setup now we are limited...
|