Forum: Troubleshooting
Tue 26 June 2012, 08:38
|
Replies: 7
Views: 12,762
pmdx 133 fried
2 boards same place. These are at the x and slave motors. PMDX thinks it might be a part failure. Anybody else seen this? Comments?
|
Forum: Troubleshooting
Tue 26 June 2012, 07:49
|
Replies: 3
Views: 10,343
|
Forum: Introduce yourself and start planning
Sat 02 June 2012, 07:23
|
Replies: 61
Views: 61,793
|
Forum: Introduce yourself and start planning
Thu 31 May 2012, 06:42
|
Replies: 61
Views: 61,793
|
Forum: Introduce yourself and start planning
Sun 20 May 2012, 08:04
|
Replies: 61
Views: 61,793
|
Forum: MechMates already cutting
Mon 19 December 2011, 19:58
|
Replies: 5
Views: 5,696
|
Forum: 40. Z-Slide
Thu 03 November 2011, 06:03
|
Replies: 12
Views: 18,377
|
Forum: 40. Z-Slide
Thu 03 November 2011, 06:02
|
Replies: 12
Views: 18,377
|
Forum: 40. Z-Slide
Wed 02 November 2011, 13:34
|
Replies: 12
Views: 18,377
Z-Plate metric to inch conversions variance
Just wanted to point out to those building an inch machine that 10 40 330 and 10 40 360 do not match on hole placement. I took these two to a machinist and they came back per plan. They could not be...
|
Forum: MechMates already cutting
Tue 04 October 2011, 06:05
|
Replies: 5
Views: 5,696
Tales of dust in Texas - Dallas TX USA
We started construction yesterday on our 5' x 10' table. We are using 3" x 8" x 1/4" square tube for our main beams, 2 1/2" x 3/16" sq tube for the legs and bracing. It will be a little beefier than...
|
Forum: 10. Base Table
Mon 03 October 2011, 06:38
|
Replies: 118
Views: 164,047
Square Tube Beams
We are just starting our build. We have left over material that we want to use as much as possible to save on cost. We have some 3" x 8" square tube that I want to use for the main beams. Anyone see...
|