Forum: General - MM Build
Mon 07 May 2012, 13:58
|
Replies: 7
Views: 9,227
|
Forum: General - MM Build
Fri 04 May 2012, 12:01
|
Replies: 7
Views: 9,227
Hmm that looks kinda of like a Master CAM?
...
Hmm that looks kinda of like a Master CAM?
Well the problem with that is I already went down the experimental design with a Joe's 4x4 only to redo it with 3/4 AL plates. I could probably figure...
|
Forum: General - MM Build
Fri 04 May 2012, 04:28
|
Replies: 7
Views: 9,227
For one it's easier for me, second the form...
For one it's easier for me, second the form factor would fit into my garage much better. I really can't afford the space to load long way, and I really do not want to try to loaded the unit over the...
|
Forum: General - MM Build
Fri 04 May 2012, 00:10
|
Replies: 7
Views: 9,227
Wide Mouth Mechmate - Suggestions
I'm slowly making my way through the many machines on the site, but so far I have not seen one that loads from the wide side. What considerations if any are there when building a machine that loads...
|
Forum: Archives
Tue 11 October 2011, 02:16
|
Replies: 8
Views: 14,831
|
Forum: Motors & their mountings
Fri 18 February 2011, 06:31
|
Replies: 278
Views: 285,160
|
Forum: The Market Place
Fri 18 February 2011, 05:23
|
Replies: 65
Views: 96,079
Mike,
Any plans to carry the standard IGUS...
Mike,
Any plans to carry the standard IGUS cable carrier. I've reviewed several threads but so far have not found part # for what everyone is using. The other thing I have not found a source for...
|
Forum: Motors & their mountings
Thu 17 February 2011, 06:25
|
Replies: 278
Views: 285,160
Has anyone used a closed loop setup like the...
Has anyone used a closed loop setup like the Shopbots have? I'm getting ready to buy parts and I'm strongly considering the OMs. If I do a closed loop system will I need a special driver and BOB? Or...
|
Forum: The Market Place
Tue 15 February 2011, 07:39
|
Replies: 1
Views: 5,250
|
Forum: The Market Place
Tue 15 February 2011, 07:38
|
Replies: 2
Views: 5,883
|
Forum: The Market Place
Tue 15 February 2011, 04:23
|
Replies: 2
Views: 5,883
|
Forum: The Market Place
Thu 10 February 2011, 01:45
|
Replies: 1
Views: 5,250
For Sale New PMDX-132 Controller BOB
Purchased this with the intent of building a second machine but I no longer have a need for it. MSRP for the board was $183 USD, would like $140 or OBO, + $14 flat rate shipping in US, Canada and...
|
Forum: MechMates already cutting
Wed 14 January 2009, 22:39
|
Replies: 62
Views: 65,601
|
Forum: Archives
Sun 27 July 2008, 23:54
|
Replies: 151
Views: 110,812
|
Forum: Archives
Sun 27 July 2008, 19:56
|
Replies: 151
Views: 110,812
|