Forum: Construction started, but not cutting yet
Fri 25 February 2011, 14:14
|
Replies: 59
Views: 75,417
PMDX 122 + 5 stppers ?
Hello,
could yoou please explain how did you contect 5 steppers to BOB with just 4 outputs ? Is such design already tested ?
Jan
|
Forum: 50. Toolheads
Fri 19 February 2010, 23:24
|
Replies: 41
Views: 39,212
Hello Ron,
Just for clarification.
Once you run M12 code the cylider is activated and drill is running, the Z axis stepper takes care about Z axis movement to drill the holes.
When drilling is done run M13...
|
Forum: 50. Toolheads
Fri 19 February 2010, 15:55
|
Replies: 41
Views: 39,212
Hello Ron,
That's clear for me.
How you generate the g-code ? Do you have to edit it manualy to change Z-axis movemnt into air on, drillling, and air off sequnce ? Or you use same macro ?
System with Z-axis...
|
Forum: 50. Toolheads
Fri 19 February 2010, 13:33
|
Replies: 41
Views: 39,212
Hello Ron,
What I do not understad how you start the drilling process.
1, Bring the drill to required coordinates- X, Y
2, What starts the drilling process ?
There is no Z axis movement
3, Do you have to...
|
Forum: 50. Toolheads
Thu 18 February 2010, 15:21
|
Replies: 41
Views: 39,212
Hello Ron,
Thanks, that's much more clear now.
How does a G code for the drill looks like, when ther is no Z axis movement ?
How would you control two different drills ?
How do you setup drill bit offset to...
|
Forum: 50. Toolheads
Thu 18 February 2010, 13:44
|
Replies: 41
Views: 39,212
Hello Ron
Just few questions for clarification:
Depth of the drilling is set just on the beginning of the drilling (z axis movement), after all the drill movement is done by pneumatic cylinder ?
How is the...
|
Forum: Miscellaneous / General / Whatever / Catchall
Sun 21 June 2009, 12:53
|
Replies: 18
Views: 25,595
Miniprof
Just check http://en.miniprof.cz/ for detailed information
|
Forum: Miscellaneous / General / Whatever / Catchall
Sat 20 June 2009, 14:50
|
Replies: 18
Views: 25,595
Be carefull - temperature
I was working for 9 years in the furniture production and my opinion is that small bander can do all jobs required for furniture making in a small starting shop. But be carefull about temperature on...
|
Forum: Motors & their mountings
Wed 26 November 2008, 13:39
|
Replies: 15
Views: 16,123
|
Forum: Motors & their mountings
Tue 25 November 2008, 14:24
|
Replies: 15
Views: 16,123
Backlash, backlask, back...
I think backlash up 2 degrees is too much. I asked MS-MOTORS.COM for the information about backlash in their gearheads and answer was 1.2 degrees. I took a look at WITTENSTEIN Alphira gearhead and...
|
Forum: Motors & their mountings
Mon 24 November 2008, 13:48
|
Replies: 15
Views: 16,123
Gearbox backlash + stepper driver
Does anybody have a information about backlash of this gearbox ? It does not have to be the information from the catalog. Information from real MM setup sould be even better.
As Richards wrotte a...
|