MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: lukelucas93
Forum: Motors & their mountings Mon 02 November 2015, 13:31
Replies: 6
Views: 12,139
Posted By lukelucas93
Hi Sean thank you for the reply, maybe Im...

Hi Sean thank you for the reply, maybe Im worrying a little too much about these motors ! I have them hooked up to the power supply now but having some trouble with getting them to turn through the...
Forum: Motors & their mountings Thu 29 October 2015, 15:00
Replies: 6
Views: 12,139
Posted By lukelucas93
Hi Brad thank you for the help! I have had my...

Hi Brad thank you for the help! I have had my head in the books again and on the web and was beginning to understand what was going on.
I had not noticed the link for the diagram on the page many...
Forum: Motors & their mountings Thu 29 October 2015, 12:42
Replies: 6
Views: 12,139
Posted By lukelucas93
Ok maybe I have left this a question a little too...

Ok maybe I have left this a question a little too broad after further reading I believe the option best for me is wiring the motors "half-coil at 35VDC and 3A". Due to my maximum voltage on the...
Forum: Motors & their mountings Thu 29 October 2015, 03:14
Replies: 6
Views: 12,139
Posted By lukelucas93
Edit. Can someone also link me to the motor cable...

Edit. Can someone also link me to the motor cable diagram for wiring them up, again I don't want the magic smoke to disappear !
Forum: Motors & their mountings Thu 29 October 2015, 02:35
Replies: 6
Views: 12,139
Posted By lukelucas93
A little help required (PK296A2A-SG7.2 setup)

So I have collected my parts and constructed the X with Z carriage I have numerous questions but to tackle the main one first. I have my PK296A2A-SG7.2's but cant seem to find the information that I...
Forum: The Market Place Fri 21 August 2015, 14:05
Replies: 5
Views: 15,268
Posted By lukelucas93
Hi Gerald thank you for the heads up on the Pm's...

Hi Gerald thank you for the heads up on the Pm's previous forums that I have been part of would not allow Pm's unless you had over a specific amount of post's whithout the message turning up in the...
Forum: The Market Place Fri 21 August 2015, 09:36
Replies: 5
Views: 15,268
Posted By lukelucas93
I have tried to send you a pm but being such a...

I have tried to send you a pm but being such a low poster I'm not sure if you'll receive it ?
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -6. The time now is 11:53.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.