MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: hennie

Forum: General - MM Operating

Fri 27 February 2009, 11:09

Replies: 18

Setting up the 0,0 point for a job . . . .

Views: 23,636

Posted By hennie

Thanks for the advice will try it tomorrow.Nils I...

Thanks for the advice will try it tomorrow.Nils I did buy the proxies but have not yet installed them had no time yet

Forum: General - MM Operating

Wed 25 February 2009, 10:56

Replies: 18

Setting up the 0,0 point for a job . . . .

Views: 23,636

Posted By hennie

I Still Battle To Get A Proper X-0/y-0 On My...

I Still Battle To Get A Proper X-0/y-0 On My Table To Start Working From.
As Can Be Seen On The Table There Is A Square That Holds My Project In Place.
Did The First Cuts With No Hassle But As I...

Forum: General - MM Operating

Wed 25 February 2009, 10:50

Replies: 18

Setting up the 0,0 point for a job . . . .

Views: 23,636

Posted By hennie

Jig shown for holding the location of "blanks" ...

Jig shown for holding the location of "blanks"

3799

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -6. The time now is 20:31.