MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: KevinL

Forum: Construction started, but not cutting yet

Fri 22 February 2008, 20:19

Replies: 6

Kitchen table project started - Antek Power Supply problem

Views: 10,964

Posted By KevinL

Just a follow up. Mike was correct, they are...

Just a follow up. Mike was correct, they are dropping the voltage in the regulator. Even mentioned that it would get hot, but it is heatsinked. I reconnected the wires in brown/orange pairs and all...

Forum: Construction started, but not cutting yet

Tue 19 February 2008, 20:00

Replies: 6

Kitchen table project started - Antek Power Supply problem

Views: 10,964

Posted By KevinL

Thanks Mike. So possibly all that is wrong with...

Thanks Mike. So possibly all that is wrong with my PS is mis-spliced color coded wires? Would it make sense that 12 VAC would be regulated to 12VDC in one bank of the PS?

Forum: Construction started, but not cutting yet

Tue 19 February 2008, 19:12

Replies: 6

Kitchen table project started - Antek Power Supply problem

Views: 10,964

Posted By KevinL

Kitchen table project started - Antek Power Supply problem

Hello Everyone,

I have been reading this forum for the past few months while gathering parts to construct a Mechmate. There is certainly a wealth of knowledge here. I have just started the...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -6. The time now is 19:10.