MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Reload this Page Search Results
Register Options Profile Last 1 | 3 | 7 Days Today's Posts

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Tokamak
Forum: Construction started, but not cutting yet Mon 09 June 2014, 14:17
Replies: 100
Views: 144,547
Posted By Tokamak
You need to slow down a little. We weren't ready...

You need to slow down a little. We weren't ready to turn on power again. We need to understand what went wrong with the initial turn on. Once the Rectifier is smoking it can continue to smoke until...
Forum: Construction started, but not cutting yet Sun 08 June 2014, 20:19
Replies: 100
Views: 144,547
Posted By Tokamak
Do you have a volt meter? It's probably not that...

Do you have a volt meter? It's probably not that bad. Don't see any wires that turned crispy.
There is a rectifier under the area you are pointing to. If you had a short down stream the rectifier...
Forum: Construction started, but not cutting yet Thu 29 May 2014, 16:00
Replies: 100
Views: 144,547
Posted By Tokamak
Krasch, Your router more that likely has 2...

Krasch,

Your router more that likely has 2 wires coming out of it. One is Hot (L1) and one is Neutral (Ret). You show one wire from the SSR and one wire to ground. NOT correct. The SSR supplies...
Showing results 1 to 3 of 3

 
Forum Jump

All times are GMT -6. The time now is 03:27.

Contact Us - www.mechmate.com - Archive - Top

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.