MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Reload this Page Search Results
Register Options Profile Last 1 | 3 | 7 Days Today's Posts

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Alan_c
Forum: Rails & Rollers Tue 14 July 2009, 09:31
Replies: 198
Views: 251,154
Posted By Alan_c
I used those countersunk cap screws, but machined...

I used those countersunk cap screws, but machined most of the cone away to produce a very low head fastner - there is not that much stress in this application to worry about the loss of strength.
...
Forum: Rails & Rollers Fri 03 July 2009, 13:12
Replies: 198
Views: 251,154
Posted By Alan_c
Leo The glazing is not on the rail, but on...

Leo

The glazing is not on the rail, but on the grinding disk, after a while it stops "cutting" and just tends to glide over the steel, tilting the skate so the initial grinds are with the leading...
Forum: Rails & Rollers Fri 03 July 2009, 00:28
Replies: 198
Views: 251,154
Posted By Alan_c
Chris Interesting proposals, question...

Chris

Interesting proposals, question regarding the height of the skate above the rail (given as 1.6mm) Will that still allow enough space underneath to fit in two bearings on a bush without the...
Forum: Rails & Rollers Thu 25 June 2009, 03:12
Replies: 198
Views: 251,154
Posted By Alan_c
That should make it a lot safer. For those...

That should make it a lot safer.

For those wanting to attatch a handle, see here (http://www.mechmate.com/forums/showthread.php?p=9551&postcount=92), this gave very good control and kept the hands...
Forum: Rails & Rollers Mon 22 June 2009, 05:21
Replies: 198
Views: 251,154
Posted By Alan_c
Your'e being ripped off, those bearings should...

Your'e being ripped off, those bearings should cost no more than R8.00 - R10.00 each, find another supplier (Bearing Man or Bearing Distributors are two I can think of)
Forum: Rails & Rollers Mon 22 June 2009, 01:02
Replies: 198
Views: 251,154
Posted By Alan_c
Johan, that looks good, only one issue - on image...

Johan, that looks good, only one issue - on image 3 I see the lower bearing sets are set at different heights, this will cause problems when turning the skate around to do the inside, its best to...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -6. The time now is 00:36.

Contact Us - www.mechmate.com - Archive - Top

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.