MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Gerald D

Forum: General - MM Operating

Tue 07 April 2009, 09:54

Replies: 18

Setting up the 0,0 point for a job . . . .

Views: 23,358

Posted By Gerald D

Chris, none of us agonize much about where to...

Chris, none of us agonize much about where to hook a tape measure. :)

Same with the machine - point it at a spot and tell it "this is zero".

Forum: General - MM Operating

Fri 27 February 2009, 09:44

Replies: 18

Setting up the 0,0 point for a job . . . .

Views: 23,358

Posted By Gerald D

How to line a tool up to a jig? Well, our jigs...

How to line a tool up to a jig? Well, our jigs are mostly bits of scrap quickly screwed to the table.....then we trim the working faces of the jig and zero according to those last known cuts. The job...

Forum: General - MM Operating

Fri 27 February 2009, 09:35

Replies: 18

Setting up the 0,0 point for a job . . . .

Views: 23,358

Posted By Gerald D

Kobus, hard stops are just as good as proximity...

Kobus, hard stops are just as good as proximity switches for zeroing the table. . . . . hold the gantry/car against the stops, switch on motors, zero the table. This done once a week or once a month,...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -6. The time now is 02:09.