MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Reload this Page Search Results
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: danilom
Forum: MechMates already cutting Sat 17 May 2014, 04:20
Replies: 518
Views: 320,738
Posted By danilom
I remember seeing that the sliding connector on...

I remember seeing that the sliding connector on gecko drive failed and caused this kind of error? Can you check that? Sometime it builds up resistance and causes heat to melt the plastic around
...
Forum: MechMates already cutting Thu 15 May 2014, 05:08
Replies: 518
Views: 320,738
Posted By danilom
first check it with multimeter for continuity...

first check it with multimeter for continuity between phases, disconnect cable from drive and from motors, then check cable and motor.

Don't try another drive :) if its short circuit it may damage...
Forum: MechMates already cutting Tue 02 April 2013, 15:06
Replies: 518
Views: 320,738
Posted By danilom
how come you got so much chatter (vertical lines)...

how come you got so much chatter (vertical lines) on the curved cuts?
was the bit too small diameter?
Forum: MechMates already cutting Mon 01 April 2013, 09:12
Replies: 518
Views: 320,738
Posted By danilom
also when you have enough spare parts, you can...

also when you have enough spare parts, you can make more machines and have spare machines :D
Forum: MechMates already cutting Tue 12 June 2012, 07:27
Replies: 518
Views: 320,738
Posted By danilom
you should have no info in Tool Table, all zeros....

you should have no info in Tool Table, all zeros. Vcarve takes care of that in gcode
Forum: MechMates already cutting Mon 28 May 2012, 01:15
Replies: 518
Views: 320,738
Posted By danilom
This might give some answer, its a hoist device ...

This might give some answer, its a hoist device

https://www.google.com/search?q=come-along
Forum: MechMates already cutting Fri 23 December 2011, 01:20
Replies: 518
Views: 320,738
Posted By danilom
and a nice minimill and minilathe :) I see that...

and a nice minimill and minilathe :) I see that the mill is cnc, did you post something about your build on the cnczone? Would like to see it if you did.
Thanks
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -6. The time now is 18:43.

Contact Us - www.mechmate.com - Archive - Top

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.