Forum: MechMates already cutting
Tue 01 July 2014, 00:00
|
Replies: 216
Views: 217,547
Bleed-off is like an alternative "vacuum Off "...
Bleed-off is like an alternative "vacuum Off " without switching on & off the motors too often which is not a good thing for the motors.
I only have 1 zone, with an open end bleed-off pipe I just...
|
Forum: MechMates already cutting
Mon 30 June 2014, 09:02
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Thu 06 February 2014, 02:59
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Sat 01 February 2014, 06:24
|
Replies: 216
Views: 217,547
Save your fingers or the VFD, u gotta decide.
I...
Save your fingers or the VFD, u gotta decide.
I just switch off the VFD manually. i.e. press the red button on the VFD. I don't find it troublesome at all.
So far, the stepper motors stay put when...
|
Forum: MechMates already cutting
Sat 01 February 2014, 05:13
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Thu 23 January 2014, 06:16
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Wed 22 January 2014, 08:38
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Fri 27 December 2013, 09:10
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Mon 04 November 2013, 05:56
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Mon 04 November 2013, 05:48
|
Replies: 216
Views: 217,547
The motor shaft can handle some overhand load,...
The motor shaft can handle some overhand load, its ok if the spur gear extend over the motor shaft, the limiting factor is how long the spur gear is.
Bringing the rail further out is another way....
|
Forum: MechMates already cutting
Mon 04 November 2013, 04:59
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Fri 01 November 2013, 01:36
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Thu 31 October 2013, 01:37
|
Replies: 216
Views: 217,547
|
Forum: MechMates already cutting
Wed 30 October 2013, 04:28
|
Replies: 216
Views: 217,547
|