Forum: MechMates already cutting
Fri 12 October 2012, 00:01
|
Replies: 137
Views: 112,915
|
Forum: MechMates already cutting
Tue 09 October 2012, 07:16
|
Replies: 137
Views: 112,915
1/4" deep groove is a tat too shallow for my...
1/4" deep groove is a tat too shallow for my liking, but you can always make yourself another if it doesn't perform ;) I can see the advantage, the grid board will last longer.
Mine is 1/2", No...
|
Forum: MechMates already cutting
Mon 08 October 2012, 23:28
|
Replies: 137
Views: 112,915
|
Forum: MechMates already cutting
Thu 26 August 2010, 03:02
|
Replies: 137
Views: 112,915
|
Forum: MechMates already cutting
Tue 10 August 2010, 19:42
|
Replies: 137
Views: 112,915
|
Forum: MechMates already cutting
Sat 03 July 2010, 09:55
|
Replies: 137
Views: 112,915
|
Forum: MechMates already cutting
Mon 15 March 2010, 05:11
|
Replies: 137
Views: 112,915
I focus on 2 parts,
1) the fabrication & ...
I focus on 2 parts,
1) the fabrication &
2)Installation.
Fabrication is heavy & dirty; A clean & tidy working area is helpful during installation. So I did all the "dirty" work while the floor...
|
Forum: MechMates already cutting
Sun 14 March 2010, 20:48
|
Replies: 137
Views: 112,915
|
Forum: MechMates already cutting
Fri 26 February 2010, 06:30
|
Replies: 137
Views: 112,915
Stan,
Drill tap is less dreadful if you treat...
Stan,
Drill tap is less dreadful if you treat it as dynamic meditation like I did. Don't forget to prepare suitable lubricant for both drilling & tapping, I used WD40 as that was the only "oil" in...
|
Forum: MechMates already cutting
Thu 25 February 2010, 22:43
|
Replies: 137
Views: 112,915
|
Forum: MechMates already cutting
Thu 25 February 2010, 21:43
|
Replies: 137
Views: 112,915
Stan, Some time ago, Joe (jehayes) told me...
Stan, Some time ago, Joe (jehayes) told me grinding the rails is the rite of passage. Now you had earned it, Congrats.
This IMHO is the most laborious & messy part of the build, it took me 3~4...
|