Bit Supplier
Hi Everyone
Doe's anybody have a good supplier that is current for Compression bits also specialty bits preferably on the cheaper side. anywhere in the world but doesn't charge the earth for postage. I am using carbidechui for end and ball nose mills. Pete |
I just found this place. The prices seem pretty fair all around. I've heard good things about southeast tool bits. I just placed my first order with them, set to arrive today.
http://www.carbideprocessors.com/ |
Pete,
I'm also looking for some compession bits, I was after 1/4" or 6mm. Have you had any luck? Anthony |
I have been using bits from Centurion Tools
http://centuriontools.com 1/4" Mortise Compression 1" Cut Length SKU: 14CR21.02.5FEM200 $27.80 I cut a lot of cheap China 3/4" ply and even after lots of sheet, they still give a good edge. If they do not ship out of the country, I would consider an order to one location if you are interested. |
Multi cam
Hi
Sorry for the delay I found Multi Cam here in Brisbane thier prices are reasonable, postage is overnight freight. I found on another site that due to the fact that I was after 1.5mmCED you could not get them so the suggestion was run a 1.5 down cut spiral then an upcut through over two passes this has given great results. Cheers Pete |
All times are GMT -6. The time now is 10:43. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.