MechMate CNC Router Forum

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)
-   Miscellaneous / General / Whatever / Catchall (http://www.mechmate.com/forums/forumdisplay.php?f=13)
-   -   Alternative to Mach3 and Breakout Board using USB (http://www.mechmate.com/forums/showthread.php?t=777)

dmoore Thu 22 May 2008 12:59

Alternative to Mach3 and Breakout Board using USB
 
Ran accross this when researching something else... It's a 5 axis controller (no drivers/motor controllers) with all the standard breakout board inputs and outputs. It's priced at $275 USD, $329 Euro. It includes a CNC controller software (like Mach3) along with the hardware, so you are paying about $100 for the hardware. Specs are:

Inputs:
Emergency stop
5x End of stroke for homing
Probe
Handwheel input
Pause
Run
USB (V2.x) from PC/Laptop

Outputs:
5x Step / Dir / amplifier enable
Emergancy Stop
Flood coolant
Mist coolant
PWM
TOOL Direction
AUX1

Max step frequency:
75 KHz step frequency,
5 Axes
Pulse width 5 uSec and up

Others
PICstep compatible
All IO buffered and filtered

Software screen photo:
http://www.usbcnc.com/images/product...perate_700.jpg

http://www.usbcnc.com/images/products/v3/engrave.jpg

http://www.usbcnc.com/images/product...ket_finish.jpg

http://www.usbcnc.com/images/product...t_bridges1.jpg

Board photo:
http://www.usbcnc.com/images/products/cpu_4_400px.jpg

http://www.usbcnc.com/index_products.html#cpuv4


All times are GMT -6. The time now is 05:00.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.