X Rail I beam thickness??
Have been looking for cheap c channel or I beams and have come empty handed on the c channel but there are plenty of cheap I beams around. My question is regarding the thickness of the web, is 1/4 inch thick too thin on a 8" beam? there are also 12" beams with the 1/4 web. Would the 1/4 web 12" work although I would have to deal with raising the cutting surface.
|
Mando.
The C channel specified for the machine can be either C 8" x 11.5#/Ft or higher which has a modulus of 8.14 in the x-x plane. The W or S shape "I beam" of that height and equal weight does have a section modulus in the x and y that meet or exceed that requirement. For example a W12x16# has a modulus of 14.9. This is only one part of the criterea where bending moment, shear and 1/360 span formula's apply...but in the spirit of the Mechmate, your "found" steel sections will be fine. If any of the qualified engineers in the room disagree....please advise. I only play an engineer on TV! :) Best, SEan |
All times are GMT -6. The time now is 17:51. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.