8' x 16' 95% Finish CNC Router For Sales
 

After many years of browsing this site and design to build my own similar to Mechmate. I spent over 2 years to put this baby together but the economy wasn't on my side I have to move to a smaller space No room for this baby. Is it all steel base welded. The top is all aluminum t-slot with linear rail and gear rack.

The pictures will tell you everything. I would say 98% complete except the setup the parameter and fine tune to make it run.

The table is 8' x 16' with one 1/2" x 5' x 10' aluminum on top.


MachMotion CNC Controller
1) X15-250 Controller
• 15” Color LCD Touch Panel
• Intel 2.0GHz Processor
• 160 GB Hard Drive
• Microsoft Windows XP
• Mach3 Installed and Mach3 Software License
• Keyboard
• Mouse
• Switch Panel (Handwheel, E-Stop, Cycle Start/Stop, Feed-rate Override, Axis Selector)
2) Installed in Mach Motion Controller Box
3) Cobra Stand
4) Mitsubishi AC Servo Motor 030 in/lb and Drives.
5) The rest you can see on pictures

Please give me an offer to own once in a lifetime opportunity.

Why don't you try to sell it on a site that is not dedicated to the mechmate design?