MechMate CNC Router Forum

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)
-   70. Control Systems (http://www.mechmate.com/forums/forumdisplay.php?f=28)
-   -   Bosch Colt with VS ON/OFF Control (http://www.mechmate.com/forums/showthread.php?t=5200)

ola16 Mon 07 March 2016 07:48

Bosch Colt with VS ON/OFF Control
 
On my 3 axis cnc I have a Bosch Colt VS router which currently is controlled manually with an ON/OFF switch. I would like to have Mach3 tuning the router ON/OFF but not sure how to achieve this; perhaps with a relay or another BOB?

I was looking at the Super-PID but that’s an expensive solution

The only BOB I have now installed is shown here:
http://www.automationtechnologiesinc...ional-breakout

Any ideas?

darren salyer Mon 07 March 2016 08:31

Welcome to the MechMate ola.
We primarily focus on the construction and use of the MechMate router.
A better place to ask your question is probably a forum dedicated to whatever control software you are currently using.

Good Luck!!

Darren

CPAC_CNC Mon 07 March 2016 10:58

I'm going to respond assuming the you are asking about a MM.

Yes, you probably want to drive a relay with a low voltage coil from an available BOB output. Or a SSR as discussed in one of the last threads in this sub-forum.

I'm a newbie here myself and think if a question is 100% applicable to a MM build then answering or discussing it can only further the knowledge and experience in the forum.

That said I don't know of any forum where asking questions that have already been answered is received well. It comes across as asking others to do work for you that you have taken no time to attempt yourself.

ola16 Mon 07 March 2016 11:42

Thank you both for your time

I understand this a MM forum however I thought a typical wiring question will be applicable to both MM and other machines

I don’t think my question is answered already, I did see a similar question posted but it was not with a C10 BOB

Finally I apologize, I’m not the type to create problems. Forums are a wonderful way to share knowledge and I respect people who use their time to help others for free

smreish Mon 07 March 2016 11:48

Ola,
The question you ask is a normal solution for the MM.
You can use the spindle (on/off) toggle on the Mach 3 software to turn a remote relay on/off.

Depending on the break out board on your particular CNC machine. You may have to purchase a few items to properly switch the size relay (current capacity) needed to operate your router.

The Mach 3 manual has a very detailed section to assist you in understanding spindle and relay control.

Good luck
Sean

lonestaral Mon 07 March 2016 18:25

http://www.mechmate.com/forums/showthread.php?t=5131

Ola, This is what I did.

There is a link to a site on post 14.
You should be able to do it.

ola16 Mon 07 March 2016 18:39

Thanks Al for the info, much appreciated


All times are GMT -6. The time now is 04:25.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.