finished cab fingerjointed with MM
 

The finger joints that I had cut in the earlier photo turned out way better than I could have imagined them to. It was also probably faster than using my dovetail jig also. I like the fit and the corners better than what I was getting with the dovetail jig. Just need more cabinet clamps though before I do any more, the glue was almost set before I finished clamping this one, because I was short on clamps.

This is a birch cab for a Marshall tube amp.

Very nice Ed, I like it. :)

Ed,

Very nice finger joint. I hope that when my MM is built, I get the same quality of work.

Umm Ed, I thought that you were a steelworker? Blokes like us are not supposed to do nice woodwork...or so I tell myself when I gouge some wood by mistake.

Good Stuff!