Coil Inductance measurement, is this normal?
I bought these 86HS9801 specs
It says the coils has 4.1mH I measured the inductance between the wires & the results as follows Coil A, 3.64mH, 3.67mH, 3.71mH, 3.67mH (Red-Yellow) Coil B, 3.61mH, 3.46mH, 3.53mH, 3.80mH (Orange-White) Coil C, 3.62mH, 3.42mH, 3.56mH, 3.77mH (Brown-Green) Coil D, 3.65mH, 3.71mH, 3.72mH, 3.66mH (Blue-Black) Are they consider normal? I'm using 48Vac tranny should give about 65~66Vdc, Consider these, 32*sqrt(3.4) = 59V (lowest measured value) 32* sqrt(3.8) =62V (highest measured value) 32*sqrt(4.1) = 65V (original based on maker's spec) The motors will run 5~7 V higher then recommended voltage. Will I be in any sort of problems? Thanks in advance. Ken |
I don't think you will have a problem . . .
If your motors run a little bit too hot, then reduce the current setting on the drive. |
Quote:
|
Anil, I'm using a DMM to measure, not sure what frequency the use though...
Gerald, Thanks again. will have to remember keep a close monitoring on the heated motors. I am also concern that the values varies greatly between coils & motors. Is that normal? |
I'm not an expert on this but i think Inductance is measured at 1Khz, rotor locked position. Anyway as Gerald said it doesn't matter here, just keep an eye and reduce voltage if motors seems overheating.
|
The biggest variance is between the 3.42mH and 3.80mH measured values. The average value between those two is 3.61mH with a variance of 0.19mH to either side. That is only 5% . . . . . which I think is darn good!
|
1 Attachment(s)
OK, inspired by gerald, I took a quick stats analysis with spreadsheet, I get standard deviation of 0.08 & a median of 3.65, that is +/-2.2%. I can ask any better then that.
This is the wiring diagram I received, want to be sure that I'm doing the correct thing. Attachment 7133 For half coil, use 1) coil A(red-yellow) & coil B(white-orange)? 2) it really doesn't matter as long as we take half of each phase? |
|
Thank you for you reply.
Ken |
All times are GMT -6. The time now is 21:42. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.