Selling all my MM parts
 

Well time is not on my side... so i am now selling all my MM parts i have collected. I have the Laser bent parts kit i have a full set of C size printed drawings (Metal head let me know if i should bury these) I have Gecko drivers x5 forget which ones when i get home i will post more info on all bits and pieces in the next two days. basically have everything except the motors, wiring, cable chain and some other small bits. I have purchased two of the electrical kits from Metal head off the top of my head not sure what all i have. Anyway post in a few days with pictures etc will part it out or sell whole for a decent discount cheers.

Sorry to hear this, Mojo.
I may be interested in some parts after you figure out what you have.
D.

Send me a list of what you have. I would like the plans.

Parts
 

I will post everything i have Monday

I'd also be interested in the list, and what you're asking for the whole lot.
Cheers,
Eli

Parts List
 

1 pmdx-126 priced at 174.00
1 smooth stepper from warp 9 priced at 180.00
2 pmdx-133 priced at 49.00 each
4 g203v gecko stepper driver priced at 147.00 each
1 router mount for the milwaukee 5625 priced at 69.95
1 laser bent parts kit minus the leveling feet priced at 520.00
1. Basic control box kit from metal head priced at 446.25
1. Windows xp machine complete with d-link ethernet card installed for smooth stepper priced at 300.00
1. Misc. 3 pin xlr connectors male and female 5 of each or more not going to count them. (free to a good home)
2 idler bearings priced at 15.00 each
rail grinding skate and bearing (no bolts) priced 35.00
machined idler and bushings priced at 100.00

look at the pictures there is more here but just going to throw it in to who ever buys lot.

I am hoping for .75 on the dollar for pricing cheers!

More pictures
 

More pictures of parts

Too bad I am in the Netherlands otherwise I would have jumped on the XLR's; last parts i need to do on wiring my controlbox the other parts I already have in my possession.

Pricing on parts seems pretty fair to me ! Hope somebody else buys it all and builds it.

14 GW3 Guide wheels for $16.95 with bearings Standard Eccentrix bushings $3.40 i have 6

Is it an Ethernet Smoothstepper?
Edit: Your first post said 5x Geckos, but your last post said you have 4?

yes
 

it is a ethernet smooth stepper and yes i counted incorrectly there are only 4 drivers

I kinda figured out the ESS part based on the prices.
Sent you a PM.

Anyone getting PM's from me?

Sold
 

All parts have been sold thank you for the inquiries and good luck in your builds