65N.cm high torque nema17 and gt2 pulley
Are 65N.cm high torque nema17 stepper motor and gt2 pulley useful for Mechmate?
http://www.robotdigg.com/product/29/...-stepper-motor http://www.robotdigg.com/product/9/G...r-6mm-gt2-belt :) |
A size 17 motor is just over 1-inch in width. It's the size motor used in many old floppy drives in computers. It had enough torque to move the "head" on the floppy drive.
A size 34 motor is about 3-1/3 inches in width. It has sufficient torque to move several computers, not just the head of the floppy drive. Right now, I can't think of an application on a CNC machine where the size 17 motor would be the best choice. Moving a pen in the Z direction might be such an application. |
3d printer
|
Sure you can put a NEMA17 motor on mechmate. I recommend you hang it over the Z-axis as a counter-weight to replace the gas spring. You would need at least 17 pieces for the job.
Its also handy as a paper weight. |
All times are GMT -6. The time now is 02:58. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.