Hi From North Florida and NEED Help :) Will Pay :)
 

I was referred here form the Sawmill Creek forum (been a member there for years.....)

Looking for someone that KNOWS how to troubleshoot and configure a CNC Plasma Cutter. This machine uses Mach 3,Gekko Drivers G201's and CNCzone torch height controller and boards. My buddy bought this used and we can't get the motors to even turn.....willing to pay a fare rate for results. Would even entertain travel expenses to the right person. The unit is located in the Pensacola,Florida area. If you know what you are doing and also live around here this offer could extend and allow you use on the machine as well! We're not dummies...I hava a cnc laser cutter, so I know the fundamentals, just need someone focused on the goal! Thanks!

Jack

Try asking over at: plasmaspider dot com