MechMate CNC Router Forum

MechMate CNC Router Forum (
-   The Show Room (
-   -   Tilting Plywood Cart (

st_indigo Tue 28 March 2017 11:31

Tilting Plywood Cart
Hey MechMateys! I made a thing, and it is glorious.

I give you the Tilting Plywood Cart! Made from 0.71 Baltic Birch (or 18mm if you prefer). Uses just over half a sheet. Four 3" swivel lock casters let you roll it any which way. 1/8x1 steel bar has a notch that locks the cart in the horizontal position, then you just pull the cord to release. The center of gravity of the sheet is over the pivot point so it won't slam down when you tilt it.

I'll type up some instructions to go along with the construction photos and plans, and post at a later date. For now, here are some photos of the completed cart.

Images Below - Admin

timberlinemd Tue 28 March 2017 20:21

I don't see the photos?

st_indigo Tue 28 March 2017 20:50

Strange.. I can see them just fine.

Is anyone else having trouble seeing the photos? If nobody but me can see them it's probably a privacy setting in google photos I need to change.

digger Tue 28 March 2017 20:53

I don't see them as well. :(

lonestaral Tue 28 March 2017 21:04

No. I cant see any photos.

st_indigo Tue 28 March 2017 21:19

Okay.. let's try this again with Flickr instead of Google:

lonestaral Tue 28 March 2017 23:43

Yes, that works

st_indigo Wed 29 March 2017 17:43

1 Attachment(s)
48x96 sheet layout for 0.70" plywood attached

pockets are milled 0.35" deep

lonestaral Wed 29 March 2017 23:04

Thanks for the PDF.
I will keep it for future use.

IamDave Thu 27 April 2017 23:47

Excellent idea I use something similar to move extira sheets around. An old sheetrock lift I modified... Thanks

All times are GMT -6. The time now is 21:49.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.