MechMate CNC Router Forum

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)
-   702. Power Supplies (http://www.mechmate.com/forums/forumdisplay.php?f=10)
-   -   Power supply insulation (http://www.mechmate.com/forums/showthread.php?t=4284)

raju.prithiv Thu 21 November 2013 09:24

Power supply insulation
 
hi there

i am newbie to this field of CNC and electronics:confused:, below is similar power supply that i use, i would like to know how to permanently insulate the AC part of the power supply?? is there any glue that i can buy. so that ones my wiring is done i could just insulate AC side:)

thanks in advance

http://image.made-in-china.com/2f0j0...5W-GK-50W-.jpg

KenC Thu 21 November 2013 21:17

Don't understand your question.

Fox Fri 22 November 2013 15:05

Hi Raju,

are you building an MM ? -> a Toroid powersupply is recommended instead of the regulated one you posted. There's a DIY powersupply section on this forum where you can find all info you need.

Not building an MM ? -> Try cnczone.com for better luck.

danilom Fri 22 November 2013 17:37

You could use, hot melt plastic gun and pour it over the contacts after you screw down the wires, if you are afraid of something getting in contact with AC clamps


All times are GMT -6. The time now is 22:35.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.